Pages: [1]

Author Topic: Problem drawing vapor  (Read 172 times)

solaris8cat

  • Newbie
  • *
  • Posts: 3
    • View Profile
Problem drawing vapor
« on: November 13, 2011, 09:56:35 PM »

Ego battery, 510T atomizer, tank cartridge

Sometimes the battery gets very hot; sometimes it tastes like I lit a filter (you all remember what that's like); sometimes I just can't draw.

Sometimes the combo is fine for a bit and then one or more of the above happens. Even with working combos, I still have to inhale pretty forcefully to get enough vapor to exhale.

I clean the atomizers several times a week per the instructions on the site.

This happens with new atomizers as well as ones that have been in use for a while.

I'm planning on ordering ego atomizers but I'm wondering what to do about the problem I have now. Please help. Better yet, an article on how to troubleshoot each component, and how to tell which component is at fault, would really be terrific!

Thanks.
Logged

admont

  • Newbie
  • *
  • Posts: 33
    • View Profile
Re: Problem drawing vapor
« Reply #1 on: November 18, 2011, 05:03:24 AM »

sounds like you are burning your atts. how do you clean them.
Logged

solaris8cat

  • Newbie
  • *
  • Posts: 3
    • View Profile
Re: Problem drawing vapor
« Reply #2 on: November 18, 2011, 05:34:28 AM »

I make a little hollow finger with a paper towel and circle it around, redoing until there is no more stain on the paper towel.  Then I puff a bit until smoke comes out.

There was a video about this a while back and I follow those instructions.

c

Logged

admont

  • Newbie
  • *
  • Posts: 33
    • View Profile
Re: Problem drawing vapor
« Reply #3 on: November 18, 2011, 04:51:13 PM »

Try using hot water than blow through the atomizer drip a couple of drops of juice on the coil and blow through the atomizerin to a paper towel.
Logged
Pages: [1]